17 Configuring the network settings [Network]
[Access interval]
Select the interval to access the “Viewnetcam.com” service server to check the IP address and the host name from the following.
10min/ 20min/ 30min/ 40min/ 50min/ 1h
•Default: 1h
[Global IP Address Notification Method]
Typically [Global IP Address Notification Method] should be set to “Normal”.
If you cannot access the camera using the registered URL 30 minutes after registering with “Viewnetcam.com”, select “Advanced”.
In this case, UPnP (→page 158) must be enabled for the camera and for the router.
•Default: Normal
17.4.3Procedure to register information for the “Viewnetcam.com” service
1.Select [Viewnetcam.com] for [DDNS] and click the [Set] button.
→A URL is displayed in [Your Account Link].
If a URL is not displayed in [Your Account Link], confirm the camera’s network settings and Internet connection, then click [Set] again.
2.Register the information for “Viewnetcam.com” by following the instructions of the wizard.
→The registration window for “Viewnetcam.com” will be displayed in a newly opened window.
When the registration window is not displayed, check that the PC is being connected to the Internet, and click the reload button of the browser.
3.Register the information for “Viewnetcam.com” by following the instructions of the wizard.
→When the message “The new camera is successfully registered to Viewnetcam.com” is displayed, close the registration window.
182
