FS6300 NMS User Manual | 7 • Configuring the 3196RC Card |
| |
Modify Test Settings
Figure 105. T1/E1 Test Settings
1.In the T1-E1 Port Configuration window for the selected link, click on Modify Test Settings.
2.Edit the desired options:
–Force Yellow Alarm: The standard used to transmit and identify the Yellow Alarm.
•linkYellowAuto—Do not force the transmission of a yellow alarm. But, yellow alarm may be automat- ically transmitted.
•linkYellowOn—Force the transmission of a yellow alarm even if the received signal is in frame.
•linkYellowDisable—Do NOT transmit a yellow alarm even if the received signal is out of frame.
–Loopback Configuration: The loopback configuration of the DS1 interface.
•dsx1NoLoop(1)—Not in the loopback state. A device that is not capable of performing a loopback on the interface shall always return this as it's value.
•dsx1PayloadLoop(2)—The received signal at this interface is looped through the device. Typically the received signal is looped back for retransmission after it has passed through the device's framing func- tion.
•dsx1LineLoop(3)—The received signal at this interface does not go through the device (minimum penetration) but is looped back out.
•dsx1OtherLoop(4)—Loopbacks that are not defined here.
–Send Code: The type of code is being sent across the DS1 interface by the device.
•dsx1SendNoCode(1)—Sending looped or normal data
•dsx1SendLineCode(2)—Sending a request for a line loopback
•dsx1SendResetCode(4)—Sending a loopback termination request
–Error Injection: Force an output error to see if the other end detects it.
–Yellow Alarm Severity: Critical / Major / Minor / Info / Ignore
–Red Alarm Severity: Critical / Major / Minor / Info / Ignore
3.Click Submit to commit your changes.
