3 • DA300 Basics
Setting Up A Job (continued)
6. Adjust the Position of the Material Prop
With a stack of material loaded:
1.Loosen the lock knob that holds the prop in position.
2.Lower the prop until its top is even with the top of the stack or the top of the stack reaches the middle of the prop.
3.Tighten the material prop's lock knob to hold it in position.
Material Prop
At this point, it's a good idea to recheck your setup adjustments:
•Is the separator gap adjustment correct?
•Is the wireframe centered under the material?
•Is the feed angle okay?
•Is there a slight clearance between the feed fence and the edge of the stack?
DA300 Printer Operator Guide |
