Polycom RMX 1500/2000/4000 Getting Started Guide
IP Network Services Required Information
When installing an RMX unit, these default IP addresses must be modified to your local network settings. Therefore it is important that before powering the RMX unit up for the first time, that you obtain the information needed to complete the Local Network Settings section of the table from your network administrator.
For RMX 1500, the network administrator should allocate three IP addresses in the local network for an MCU with a MPMx card.
For RMX 2000, the network administrator should allocate four IP addresses in the local network for an MCU with one MPM/MPM+/MPMx card and five IP addresses for an MCU with two MPM/MPM+/MPMx cards.
For RMX 4000, the network administrator should allocate four IP addresses in the local network for an MCU with one MPM+/MPMx card and up to seven IP addresses for an MCU with up to four MPM+/MPMx cards.
Table
Parameter | Factory Default | Local Network Settings |
|
|
|
Control Unit | 192.168.1.254 |
|
IP Address |
|
|
|
|
|
Control Unit | 255.255.255.0 |
|
Subnet Mask |
|
|
|
|
|
Default Router IP | 192.168.1.1 |
|
Address |
|
|
|
|
|
Shelf Management IP | 192.168.1.252 |
|
Address |
|
|
|
|
|
Signaling Host IP | – |
|
address |
| |
|
| |
|
|
|
Media Board IP | – |
|
address (MPM 1) |
| |
|
| |
|
|
|
Media Board IP |
|
|
address (MPM 2) | – |
|
RMX 2000/4000 only |
|
|
|
|
|