RAD Data comm ASMI-450 Clr Alm, CLR Loop, ASMi-450 Command Set Description, Format, Use

ASMi-450 Control from the Control Port

4.5 ASMi-450 Command Set Description

This section describes the ASMi-450 commands. The commands are listed in alphabetical order. The description includes command format, use, and options.

The following notational conventions are used below:

[	]	square brackets indicate optional entry/parameter
'	'	single quotes delimit user entry
<CR>		indicates the pressing of the carriage return key

CLR ALM --------------------------------------------------------------------------------------

Purpose	Clear the alarm buffer.
Format	CLR ALM [/A]
Use	1.	To clear only alarms of the ON type stored in the alarm buffer (see Table 5-1):
		CLR ALM<CR>
	2.	To clear all the alarms stored in the alarm buffer (including ON/OFF alarms):
		CLR ALM /A<CR>
	3.	You will see the time and date, followed by the ASMi-450 prompt.

CLR LOOP ------------------------------------------------------------------------------------

Purpose	Deactivate the specified user-initiated loopback or test.
Format	CLR LOOP [looptype] or CLR LP [looptype]
Use	1.	To deactivate the local (L) loopback on the user's port of the local ASMi-450, type:
		CLR LOOP L PORT<CR> or CLR LP L PORT<CR>
	2.	To deactivate the remote (R) loopback on the user's port of the remote ASMi-450,
		type:
		CLR LOOP R R PORT<CR> or CLR LP R R PORT<CR>
	3.	You will see the time and date, followed by the ASMi-450 prompt.
	4.	If no loopback of the specified type is now activated, you will receive ERROR 2.

ASMi-450 Installation and Operation Manual 4-9