RAD Data comm ASMI-450 System Configuration Parameters, C. System Parameters, Designation, Values

Front-Panel Operating Instructions

3.4 System Configuration Parameters

Table 3-3 lists the available system configuration parameters and their functions. The table also lists the parameter values included in the ASMi-450 default configuration.

Table 3-C. System Parameters

Designation		Function			Values
CLK MASTER	Selects the master timing reference.			ASMi-450 configured as central (CNTR) unit:
				EXT	Locked to the clock signal provided by the
	The available selections depend on				user's equipment (this locks the HDSL
	the ASMi-450 function. Refer to				transmit timing to the timing of the incoming
	Section 1-2 for details				user's signal).
				INT	Internal oscillator.
				Default: EXT
				ASMi-450 configured as remote (REM) unit:
				Always locked to the recovered receive clock of the
				HDSL line. This locks the user's equipment timing to
				the timing of the HDSL signal.
ACTIVE TS	Determines the number of active			The number of time slots can be set from 1 up to the
	HDSL time slots, which determines			maximum supported by the corresponding ASMi-450
	user's data rate.			model
	The maximum number of active			Default: Maximum number of time slots supported
	time slots depends on the ASMi-			by the corresponding ASMi-450 model
	450 model:
	-	ASMi-450/768:	12 time slots
	-	ASMi-450/1152:	18 time slots
ETHERNET MODE	Selects the Ethernet LAN traffic			HALF	Half duplex operation
	transfer mode (displayed only for			FULL	Full duplex operation
	ASMi-450 version with the
	Ethernet interface)			Default: HALF
BRIDGING	Selects the Ethernet traffic control			FILTER	The internal bridge of the ASMi-450 is
	function (displayed only for				enabled, and filters the traffic transferred to
	ASMi-450 version with the				the remote end
	Ethernet interface)			TRANS	The internal bridge of the ASMi-450 is
					disabled, and the Ethernet traffic is
					transparently transferred (LAN extender
					function)
				Default: FILTERED

3-8 ASMi-450 Installation and Operation Manual