RAD Data comm ASMI-450 operation manual Dsp St Port, Purpose Format Use Display Format

REM REM PORT: remote port loopback

ASMi-450 Installation and Operation Manual

∙

Displays the type of the user's port interface ('interface' stands for the interface type: V.35, X.21, RS-422,RS-530, or ETHERNET). Displays the state of each type of loopback that can be activated ACTIVATED LOOPS by command from the local ASMi-450 unit on either the local, or the remote unit:

∙ LOCAL PORT: local port loopback on the local unit.

ASMi-450 Control from the Control Port

Display Format

A typical HDSL line status display is shown below.
STATUS OF LINE
ANALOG FRONT END TYPE = 784K
LOCAL LINE ALARMS = SYNC LOSS	SIGNAL LOSS
OFF	OFF

The fields included in the status information display are listed below:

ANALOG FRONT END TYPE Displays the nominal data rate on the HDSL line:

	784 kbps for ASMi-450/768.
LINE ALARMS	Displays the state of the line alarms on the HDSL
	line:
	SIGNAL LOSS	ON indicates loss of HDSL
		input signal.
	SYNC LOSS	ON indicates loss of
		synchronization to the HDSL
		signal.

DSP ST PORT -------------------------------------------------------------------------------

Purpose

Format

Use

Display Format

Display status information on the user's port.

DSP ST PORT [Option]

1.To display the current status information for the user's port, type:

DSP ST PORT

A typical user's port status display is shown below.

STATUS OF PORT
INTERFACE TYPE	=	'interface'
LOCAL UNIT ACTIVATED LOOPS	=	LOCAL PORT	REM REM PORT
		NO	NO
REMOTE UNIT INITIATED LOOPS =		REM PORT
		NO

The fields included in the ASMi-450 status information display are listed below:

TYPE

LOCAL UNIT

4-20