RAD Data comm ASMI-450 operation manual Def Sp, Purpose Format Use

ASMi-450 Control from the Control Port

2. The password entry screen appears, e.g.:

NEW PASSWORD (4 to 8 CHARS) =

CURRENT PASSWORD = 'password'

where 'password' is the current password.

3.Type the required password. Carefully check that the specified password has been indeed typed in, and then press <CR>. The ASMi-450 will display the TIME and DATE fields, followed by the ASMi-450 prompt.

Note

Before entering a new password, make sure that the PSWD section of the ASMi-450 internal switch S1 is not set to ON, because in such a case the default password (ASMI) is enforced.

DEF SP-----------------------------------------------------------------------------------------

Purpose

Format

Use

Assign values to control port parameters. See Section 3-5 for parameter description and allowable ranges, and Section 3-7 for practical selection recommendations.

DEF SP

1. Type

DEF SP<CR>

2.The first page of the control port parameters data form is displayed. A typical form is shown below. The form presents the current parameter values as defaults.

SPEED	DATA	PARITY	INTERFACE	CTS DCD_DEL	DSR
AUTO	8	NO	DCE	=RTS 0_MSEC	ON

3.Change the parameter values as follows:

∙Bring the cursor to the beginning of the first field to be changed by pressing the space bar.

∙To change the selected field, press F or B to scroll among the available selections.

∙When the desired selection is displayed, press the space bar to move to the next field.

4.When done, press <CR> to display the next page of control port parameters. A typical form is shown below.

POP_ALM	PWD	LOG_OFF	AUXILIARY DEVICE
NO	NO	NO	TERMINAL

5. Repeat the procedure given in Section 3 above to select new parameter values.

ASMi-450 Installation and Operation Manual 4-13