RAD Data comm ASMI-450 Preparation for Use of Supervision Terminal, Internal Settings

ASMi-450 Control from the Control Port

ASMi-450 Preparations

Supervision Terminal

Connections

4.3 Preparation for Use of Supervision Terminal

Internal Settings

See Section 2-4 for detailed information.

In general you must enter a password when you start a control session. If the password is incorrect, the ASMi-450 will not respond. This can be corrected by appropriate setting of the PSWD section of switch S1. Set the PSWD section of switch S1 as follows:

OFF	In this position, you can define your own password and node
	address.
ON	Set the switch section to ON to restore the default ASMi-450
	password (ASMI), and change the node address to the default
	value of 0. The change will be made after you turn the
	ASMi-450 off for a short time, and then turn it back on.

Control Port Configuration

Configure the ASMi-450 control port as required. See Sections 3-5 through 3-7.

If the control port parameters are not correct, the ASMi-450 will not respond. This can be corrected by appropriate setting of the DEF SP section of switch S1. Set the DEF SP section of switch S1 as follows:

OFF	In this position, you can define the desired control port
	parameters.
ON	Set the switch section to ON to restore the default control port
	parameters. The change will be made after you turn the
	ASMi-450 off for a short time, and then turn it back on.

Configure the terminal for the same communication parameters you selected for the ASMi-450 control port.

Connect the control cable (coming directly from the terminal, or from the modem used to connect the terminal) to the CONTROL DCE connector of the ASMi-450. See Appendix A for cable wiring information.

Turn the control terminal on and when applicable, turn on the modems and the other communication equipment used to connect the terminal to the ASMi-450.

ASMi-450 Installation and Operation Manual 4-5