RAD Data comm ASMI-450 Remote DB, Remote Alarm, Remote Self Test, Remote Hardware, Remote Pswrd

ASMi-450 Control from the Control Port

Table 4-2. Control Terminal Alarm Messages (Cont’d)

Alarm No.	Alarm Syntax	Meaning	State	Time
16	REMOTE DB	The data base currently stored in the non-	[ON]	hh:mm:ss
	CHECKSUM ERROR	volatile memory of the remote ASMi-450
		is corrupted. Message can appear only
		upon power-up
17	REMOTE ALARM	The alarm buffer of the remote ASMi-450	[ON] [OFF]	hh:mm:ss
	BUFFER OVERFLOW	is full, and new alarms overwrite the older
		alarms
18	REMOTE SELF TEST	A fault has been detected in the remote	[ON]	hh:mm:ss
	ERROR	ASMi-450 during the power-up self-test
19	REMOTE HARDWARE	A hardware fault has been detected in the	[ON]	hh:mm:ss
	FAILURE	remote ASMi-450
20	REMOTE PSWRD	Section PSWD of switch S1 of the remote	[ON]	hh:mm:ss
	SWITCH IS ON	ASMi-450 is set to ON
21	REMOTE SP-PAR	Section DEF SP of switch S1 of the	[ON]	hh:mm:ss
	SWITCH IS ON	remote ASMi-450 is set to ON
22	REMOTE DB-INIT	Section DB INIT of switch S1 of the	[ON]	hh:mm:ss
	SWITCH IS ON	remote ASMi-450 is set to ON
23	REMOTE REAL TIME	The battery that powers the remote	[ON]	hh:mm:ss
	CLOCK BATTERY	ASMi-450 internal real-time clock when
	FAILURE	ASMi-450 is not powered has failed
24	REMOTE REVERSE	Reversed loop polarity has been detected	[ON]	hh:mm:ss
	POLARITY	by the remote ASMi-450
25	REMOTE SIGNAL LOSS	A report of loss of HDSL input signal at	[ON] [OFF]	hh:mm:ss
		the remote ASMi-450 has been received
		via the HDSL line
26	REMOTE SYNC LOSS	A report of HDSL loss of synchronization	[ON] [OFF]	hh:mm:ss
		at the remote ASMi-450 has been received
		via the HDSL line
27	REMOTE LOW	The far-end block error rate (FEBE)	[ON]	hh:mm:ss
	QUALITY ALARM	reported via the HDSL line exceeds 10-7
28	REM TRANSMIT SLIP	A slip has been detected on the remote	[ON]	hh:mm:ss
		transmit path
29	REM RECEIVE SLIP	A slip has been detected on the remote	[ON]	hh:mm:ss
		receive path

4-18 ASMi-450 Installation and Operation Manual