RAD Data comm ASMI-450 Def Name, Display Fields, Telnetapathytime, Ipaddress, Read Community

ASMi-450 Control from the Control Port

Display Fields

4. A typical display, as seen after all the parameters are selected, is shown below:

TELNET_APATHY_TIME			10 MIN
IP_ADDRESS XXX.XXX.XXX.XXX
READ	COMMUNITY	public
WRITE COMMUNITY		private
TRAP	COMMUNITY IS public

where X stands for the digits of the IP address.

The agent parameters displayed on the data form, and their range of values, are as follows:

TELNET_APATHY_TIME	Press the F or B keys to select the time, in minutes,
	after which a Telnet connection will be automatically
	terminated if no incoming activity is detected.
	The available values are 10MIN, 15MIN, and 20MIN.
IP_ADDRESS	Type in the IP address assigned to the ASMi-450
	SNMP agent in the dotted-quad format (four groups of
	digits in the range of 0 through 255, separated by
	periods).
READ COMMUNITY	Type in the name of the SNMP community that has
	read-only authorization (the ASMi-450 SNMP agent
	will accept only getRequest and
	getNextRequest commands from management
	stations using that community). You may enter up to
	32 alphanumeric characters.
WRITE COMMUNITY	Type in the name of the SNMP community that has
	read-write authorization (the ASMi-450 SNMP agent
	will also accent setRequest commands from
	management stations using that community). You may
	enter up to 32 alphanumeric characters.
TRAP COMMUNITY	Type in the name of the SNMP community to which
	the ASMi-450 SNMP agent will send traps. You may
	enter up to 32 alphanumeric characters.

DEF NAME------------------------------------------------------------------------------------

Purpose	Define the node name (up to eight alphanumeric characters).
Format	DEF NAME
Use	1. To define the ASMi-450 node name, type:
	DEF NAME<CR>

ASMi-450 Installation and Operation Manual 4-11