DEF SYS---------------------------------------------------------------------------------------
Purpose | Assign values to system parameters. |
|
| |
Format | DEF SYS |
|
|
|
Use | 1. Type |
|
|
|
| DEF SYS<CR> |
|
|
|
| 2. The system parameters data form is displayed. A typical form for an | |||
| with Ethernet interface is shown below. The form presents the current parameter | |||
| values as defaults. For | |||
| BRIDGING fields always show N/A. |
|
| |
| CLK_MASTER ACTIVE_TS | ETHERNET_MODE | BRIDGING | |
| EXT | 18 | HALF_DUP | FILTER |
See Section
3.Change the parameter values as follows:
∙Bring the cursor to the beginning of the first field to be changed by pressing the space bar.
∙To change the selected field, press F or B to scroll among the available selections.
∙When the desired selection is displayed, press the space bar to move to the next field.
4.After the desired parameter values are selected, press <CR> to end. The
DEF TERM ------------------------------------------------------------------------------------
Purpose | Define the control sequences to be sent to the supervision terminal to perform the |
| following terminal control functions: |
| ∙ Clear screen. |
| ∙ Move cursor to screen home position. |
| ∙ Move cursor to the right by one position. |
| This command is similar to the F command (see F section below), except that it also |
| enables you to specify a terminal type and the |
| itself for using the corresponding control sequences. The terminal types supported by |
| this command are: |
| |
| The codes used by the supported terminals are listed in the following chart: |
