User Function Settings List

01MCF(SINGLE-LOC.)

This function automatically prints a Message Confirmation Report after each single-location transmission or polling transmission. The report provides information about the transmission. Refer to the “Reports, Message Confirmation Report” section of this handbook.

Available settings are ON and OFF (default).

02 MCF(MULTI-LOC.)

This function automatically prints a Message Confirmation Report after each multiple-location transmission. The report provides information about the transmission. Refer to the “Reports, Message Confirmation Report” section of this handbook.

Available settings are ON (default) and OFF.

03 ERR REPORT (MCF)

This function automatically prints a Message Confirmation Report every time an error occurs during a transmission or polling transmission operation. The report provides information about the transmission. Refer to the “Reports, Message Confirmation Report” section of this handbook.

Available settings are ON (default) and OFF.

04 IMAGE IN MCF

When a message confirmation of a memory transmission is printed, this function adds a portion of the first page of the document that was sent. This feature makes it easier to identify a fax, but it may present security problems if you are sending sensitive documents.

Available settings are ON (default) and OFF.

05 SENDER ID

This function controls the printing of your fax machine’s Sender ID on the faxes you send. Refer to the “Programming Required Information, Fax Identification” section of this handbook for details. When turned on, the Sender ID will be printed on each page slightly outside the image area of your document. The default setting is ON.

!In order to meet FCC requirements, you must have this feature set to ON and have a valid Sender ID

programmed in your fax machine.

44 Handbook

Page 44
Image 44
Samsung 5400 manual User Function Settings List, Mcfsingle-Loc