Samsung 5400 manual Incoming Ring, Remote Receive, 18 MEM./FEEDER SW, NOT USED 20 ECM FUNCTION

16 INCOMING RING

This function controls the telephone ringing sound your fax machine makes when a call comes in. When set to off, it does not ring during incoming calls. The available settings are:

ON (default): Only rings when set to Manual Receive [TEL] mode or when the RING RESPONSE function is set to 5, 10, or 20 seconds.

OFF: Does not ring when a call comes in.

DRC (distinctive ring cancel): Rings for each incoming call with the same tone, even if you have set function setting 12, DISCTINCTIVE RING to on.

17 REMOTE RECEIVE

This function lets you use an attached phone to tell your fax machine to switch from telephone to fax mode so it can receive an incoming fax. Use the keypad of an external telephone to enter the remote receive number you have programmed into your fax machine.

In addition, if your fax machine is in TAD mode, a caller can enter the programmed remote receive number after leaving a voice message; this enables the fax machine to receive a fax from the caller.

Refer to the “Answering Mode, Using Your Fax with an Answering Machine [TAD]” section of this handbook. Available settings are OFF (default), 00, 11, 22, 33, 44, 55, 66, 77, 88, 99, **, and ##.

18 MEM./FEEDER SW.

The fax unit is set to scan documents in and transmit them from memory. This function controls how manual feed transmissions are performed. Available settings are FEEDER (the default setting) and MEMORY.

19 NOT USED

20 ECM FUNCTION

The error correction mode function may help your fax machine improve communication in areas where telephone line conditions are marginal. Refer to the “Problem Solving” section of this handbook for other suggestions if you have communication problems. Available settings are ON (default) and OFF.

21 REMOTE DIAGNOSIS

The remote diagnostics feature allows a service person remotely to dial and service your fax machine. Available settings are ON and OFF (default).

Handbook 159