Samsung 5400 manual Monitor Volume

06 MONITOR VOLUME

This function sets the volume for telephone line monitoring during dialing.

Available settings are LOW (default), HIGH, and OFF.

07 BUZZER VOLUME

This function sets the volume of the various tones your fax machine emits during operation. Available settings are LOW, MIDDLE (default), and HIGH.

08 CLOSED NETWORK

This function allows you to program your fax machine to refuse to communicate with locations whose telephone numbers have not been programmed into your One Touch keys or Auto Dial locations. Using this function, you can set up a closed network of fax machines. Refer to the “Security, Rejecting Unsolicited (Junk) Fax Messages” section of this handbook. If you do not want your fax machine to transmit faxes to or receive faxes from locations outside your network, select T/R. If you only want your fax machine to refuse to receive faxes from outside your network, select RX.

Available settings are OFF (default), T/R, and RX.

09 TX MODE DEFAULT

Your fax machine is set for the STD (standard) resolution setting and the NORMAL contrast setting. If you consistently send faxes that require some other combination of transmission modes, use this function setting to change the default modes. While you are programming, the new default combinations appear on the lights above the Yes ◀ and the No ♣ keys. The default is

STD/NORMAL.

10 T/F TIMER PROG.

When set to the telephone/fax answering mode, your fax machine automatically distinguishes between incoming voice and fax calls. If the incoming call is a voice call, the fax machine rings to tell you to pick up the handset. If you do not answer, the fax machine automatically switches back to fax mode to allow the calling party to send a fax. The T/F TIMER function controls how long it waits before switching back to fax mode.

Available settings are 20 SECONDS or 35 SECONDS (default).

Handbook 45