INITIAL SET2
52 English
SETTINGS
8Turn the jog dial to set T2 (minutes) to
“30” (minutes), and then turn the shuttle
dial clockwise.
“00:” from T3 flashes (indicating the hour).
Repeat steps 4 through 7 to make hour and minute
settings for T3 and T4.
9In the same manner as described set
the hours and minutes of T1, T2, T3, and
T4 for “TIME PERIOD B” settings.
For both TIME PERIOD A and TIME PERIOD B, all
settings are “00:00” by default.
zSettings for T1 through T4 cannot be made in such a
way that they extend over two days (i.e., include
midnight). If “00:00” (midnight) must be set, this should
be done using T1.
Any setting of “00:00” for T2 through T4 will be skipped.
Example: T1 T2 T3 T4
06:00 12:00 18:00 00:00
In the above example, T4 (00:00) is skipped and T3
operates between 18:00 and 06:00.
zFurthermore, when T1 through T4 are all set to “00:00”,
all but T1 are ignored, and T1 operates from midnight to
midnight.
Example 2: Setting time period operation as follows.
Automatic selection and monitor masking for TIME
PERIOD A.
Motion sensing for TIME PERIOD B.
1Turn the jog dial to move the cursor to
“SEQUENCE” within “SELECT TIME
PERIOD”, and then turn the shuttle dial
clockwise.
“TIME PERIOD A” flashes.
2Turn the jog dial to select “TIME
PERIOD A” or “TIME PERIOD B”, and
then turn the shuttle dial clockwise.
The cursor moves to “MASK”.
3Set the time period for “MASK” and
“MOTION SENSOR” in the same way.
4Press the [EXIT] button.
The setting procedure is ended and the display returns to
the normal screen.
Automatic selection, masking, and motion sensors are all
set to “TIME PERIOD A” by default.
zAs a result of the above operations, “SEQUENCE” are
updated using main monitor and monitor 2 settings on
P.90; “MASK” are updated using mask settings from on
P.92; and “MOTION SENSOR” are updated using
motion sensor settings on P.72.
Time period operations settings
EXIT
e00_l8hbe_xe_7.book Page 52 Tuesday, April 27, 2004 10:35 AM