Savin Remote Transfer with UUI, Note, Note, Note, Preparation, User Function, C Specify the UUI, J Press the {q} key twice, I Repeat step H for all end receiv- ers

Reception Features

❒If you keep on getting the er- ror tone, the end receiver may not be registered in the Quick Dial key or Speed Dial you are specifying.

❒When the optional Function Upgrade Unit is installed, en- ter a Group number in the range 01 to 30.

I Repeat step H for all end receiv- ers.

Note

	❒ If you specify 30 end receivers,
4
	the Transfer Request is accepted
	and you will hear a "pee pee pee
	pee" tone. In this case, proceed
	to step K.

J Press the {q} key twice.

The Transfer Request is accepted and you will hear a "pee pee pee pee" tone.

K When you hear the reception tone again, press the {Start} key.

Your document will be sent.

Remote Transfer with UUI

This function requires the optional ISDN Unit.

It allows G4 faxes with the UUI feature to make Transfer Requests to this machine using UUI instead of a push signal with the same code. See p.83 “UUI”.

Preparation

You need to store the Tone (UUI) function in a User Function key be- forehand. See p.154 “User Function Keys”.

Note

❒You can specify up to 30 end re- ceivers with UUI.

❒You can select whether or not the machine accepts remote transfers with User Parameters. See p.178 “User Parameters” (switch 11 bit 0).

How to make a Remote Transfer Request (UUI)

This procedure describes how to make a Transfer Request to this machine from the requesting party's ma- chine.

A Set the original and select any scan settings you require.

B Select G4 then enter the fax number of the Transfer Station.C Specify the UUI.

Note

❒On machines of this type, press the {User Function} key assigned to Tone (UUI) then enter the UUI.

118