Specifications

Note

❒You can still send fax messages stored in memory while the machine is in En- ergy Saver Mode.

❒Even in Energy Saving Standby mode, indicators that blink or light during communication or reception still work. When the Substitute Reception, Mem- ory Lock or Confidential message indicator lights, exit Energy Saver Mode and take appropriate action.

❒You can specify High Temperature Standby mode in combination with either Energy Saver Standby mode or Fax Standby mode. If High Temperature Standby mode is turned on, the machine starts a new print job in less time than the wait time described in the table above, provided it is initiated within the time specified with User Parameters (switch 31 bits 7,6) after the previous print job is complete. You can make necessary settings with User Parameters. See p.178 “User Parameters” (switch 05 bit 3).

❒You can specify the duration of time before the machine exits High Temper- ature Standby mode with User Parameters. See p.178 “User Parameters” (switch 31 bits 7,6).

❒While the Night Timer is activated, the machine stays in the Energy Saver Standby mode. If a fax message comes in while the heater is turned off, it is stored in the machine's memory (Substitute Reception), and printed after the specified time is reached. See p.176 “Night Timer”.

Entering Energy Saver Mode

The machine enters Energy Saver Mode when:

•Nobody uses the machine for about 5 minutes.

•The user holds down the {Clear Modes/Energy Saver} key for about 2 seconds.

Note

❒If you wish to change the five minute period to one or three minutes, or if you do not want your machine to enter the Energy Saver Mode automatically,

please contact your service representative.

10

 

-When the machine does not enter Energy Saver Mode

The machine does not enter Energy Saver Mode when:

•The optional Handset is not placed correctly

•The main paper tray is not loaded into the machine

•Either the ADF unit, ADF cover or the side cover is open.

•An original is jammed

•The machine is out of order

•There is no paper loaded into either the main paper tray or the optional Paper Tray Unit

301