Savin Using On Hook Dial with ISDN, Note, Note, Stop, Note, Reference, Limitation, Preparation, On Hook Di- al, C Press [Dialing], B Dial the fax number

Other Transmission Features

Using On Hook Dial with ISDN

This feature requires the optional ISDN Unit.

When only connected to an ISDN line, the On Hook Dial feature becomes available for ISDN.

	The following example describes how
3	to use this feature to connect to a fax
	information service.

Preparation

You need to set the "Selecting the line for On Hook Dial" to "ISDN" with User Parameters. See p.178 “User Parameters” (switch 21 bit 0).

Note

❒When ISDN is selected for the On Hook Dial, the optional handset or an external telephone can only be used for making phone calls. You cannot transmit faxes with the Manual Dial function or receive faxes with the Telephone Mode. See p.88 “Manual Dial” and p.113 “Telephone Mode”.

A Press the {On Hook Dial} key.

B Dial the fax number.

Limitation

❒Do not pause for more than 5 seconds between dialing digits. If more than 5 seconds passes, transmission will start automat- ically.

Note

❒If you incorrectly enter the number, press the {On Hook Di- al} key, the {Stop} key or the

{Clear Modes/Energy Saver} key and perform the operation again.

❒You can also enter the sub-ad- dress and UUI. The correct in- put sequence is as follows: "Fax number" "/" "Sub-address" "•" "UUI"

❒Press 0 to 1 key to adjust the monitor volume.

Reference

p.82 “Sub-address”

p.83 “UUI”

C Press [Dialing].

Note

❒Transmission will begin auto- matically 5 seconds after enter- ing the fax number.

86