Siemens SIMATIC NET PROFIBUS manual Using the Pulling Loop

SIMATIC NET PROFIBUS PCF Fiber Optic Standard Cable

Using the Pulling Loop

Loop

Protective sleeve

Die SIMATIC NET PCF Fiber Optic Standard cable is fitted	The tensile load is applied to the loop and is distributed over
	the Kevlar fibers (strain-relief elements) of the PCF standard
with a pulling loop at one end. It consists of the loop and a
	cable. The protective sleeve surrounds the cores with their
protective sleeve.
	preassembled connectors and prevents them from kinking.
	Caution: Pull in the cable using only the loop. Never pull on the
	protective sleeve or the outer jacket of the cable.

After the cable has been installed, the pulling loop must be removed. Cut open the back end of the protective sleeve with scissors for a length of approximately 10 cm.

Caution: Make sure that you do not damage the cords beneath the protective sleeve.

Free the cords from the protective sleeve and cut away the Kevlar fibers with scissors.

Caution: Never cut the black or orange cords.

Carefully remove the pulling loop from the end of the cable by pulling on the loop.

The job is done!

Page 4