Fax

8.1AT*E2FAX Ericsson M2M Fax Comm. Baud Rate Modification

Description

Command

Possible Responses

Request change of fax

AT*E2FAX= <RcV>

comm. baud rate

 

Displays currently set

AT*E2FAX?

rate

 

•_ ERROR

•_ OK

•_ *E2FAX: <RcV>

•_ ERROR

Shows if the command

AT*E2FAX=?

•_ *E2FAX: (list of

is supported

 

 

supported <RcV>s)

 

 

 

 

•_ ERROR

This command allows the modification of the factory default RS232 comm. setting between standard 9600 baud and 19200 baud. This is needed as the addition of fax capabilities, within the module, require communication between fax applications and the module to run at a higher baud rate than the fax transmission baud rate (In this case the fastest transmission rate is 9600 baud). Once this command has been performed, the user must then execute the AT&F command to reset the module with the new RS232 comm's baud rate.

The AT*E2FAX command allows the user to:

“Configure” the RS232 Comm. speed default factory profile, specifying whether the speed should be 9600 baud (standard) or 19200 baud for FAX application comm. This value will then be used once the AT&F command is next used.

“Read” what value this default factory profile has been set to.

<RcV> Description

0Configure RS232 default setting to 9600 baud

1Configure RS232 default setting to 19200 baud

•_

Owner’s Manual

Rev 1.0

Page 134 of 134