<type> Description

129129 ISDN/telephony numbering plan, national/international unknown

145

145 ISDN/telephony numbering plan, international

 

number

161161 ISDN/telephony numbering plan, national number

128-255 Other values refer to GSM 04.08 section 10.5.4.7

16.15AT+CLIR Calling Line Identification Restriction

Description

Command

Possible Responses

Request calling line

AT+CLIR=[<n>]

identification restriction

 

Read the current setting AT+CLIR?

Test if the command is AT+CLIR=? supported

•_ +CME ERROR <err>

•_ OK

•_ ERROR

•_ +CLIR: <n>,<m>

•_ +CME ERROR <err>

•_ OK

•_ ERROR

•_ +CLIR: (list of supported <n>s)

•_ +CME ERROR <err>

•_ OK

•_ ERROR

This command refers to CLIR-service according to GSM 02.81 that allows a calling subscriber to enable or disable the presentation of the CLI to the called party when originating a call.

Set command overrides the CLIR subscription (default is restricted or allowed) when temporary mode is provisioned as a default adjustment for all following outgoing calls. Using the opposite command can revoke this adjustment. If this command is used by a subscriber without provision of CLIR in permanent mode the network will act according GSM 02.81.

The setting shall be per logical channel.

When the MS is turned off and then turned on again the parameter setting <n> shall turn back to default, i.e. the presentation of CLI shall be used according to the subscription of the CLIR service, <n> is 0.

Owner’s Manual

Rev 1.0

Page 267 of 267