3.4ATS3 Command Line Termination Character

Description

Command

Possible Responses

Set Command Line

ATS3=<value>

Termination Character

 

Read the current setting ATS3?

Show if the command is ATS3=? supported

•_ OK

•_ ERROR <value>

S3: (list of supported <value>s)

This S-parameter represents the decimal IA5 value of the character recognised by the DCE from the DTE to terminate an incoming command line. It is also generated by the DCE as part of the header, trailer, and terminator for result codes and information text, along with the S4 parameter.

The previous value of S3 is used to determine the command line termination character for entry of the command line containing the S3 setting command. However, the result code issued uses the value of S3 as set during the processing of the command line. For example, if S3 was previously set to 13 and the command line “ATS3=30” is issued, the command line is terminated with a <CR> character (IA5 0/13), but the result code issued uses the character with the ordinal value 30 (IA5 2/14) in place of the <CR>.

<value>

Description

 

 

13

Command line termination character, Default value

 

 

0 to 127

Command line termination character

 

 

3.5ATS4 Response Formatting Character

Description

Command

Possible Responses

Set Response

ATS4=<value>

Formatting Character

 

Read the current setting ATS4?

Show if the command is ATS4=? supported

•_ OK

•_ ERROR <value>

S4: (list of supported <value>s)

Owner’s Manual

Rev 1.0

Page 73 of 73