Show if supported and

ATZ=?

Z: (list of supported

list available parameter

 

<profile>s)

range

 

 

 

 

 

This command instructs the DCE to set all parameters to their default values as specified by the user. Consider hardware configuration switches or non- volatile parameter storage (if implemented) when using this command.

Commands included on the same command line as the Z command will be ignored.

<profile >

Description

0Select the user profile to restore

10.9AT+CMUX Switch to 07.10 Multiplex Protocol

Description

Command

Possible Responses

Switch to 07.10

Returns current setting for multiplexer

Show list of supported services

AT+CMUX=<transpar +CME ERROR: <err> ency>[,<subset>[, <port_speed>[,<N1> [,<T1>[,<N2>[,<T2

>

[,<T3>[,<k>]]]]]]]]

AT+CMUX? •_ +CMUX:<transparency>, <subset>,<port_speed>,<N1 >,<T1>,<N2>,<T2>,<T3>[, <k>]

 

•_ +CME ERROR: <err>

AT+CMUX=?

•_ +CMUX: (list of supported

 

 

<transparency>s),

 

(list of supported <subset>s),

 

(list of supported

 

<port_speed>s),

 

(list of supported <N1>s),

 

(list of supported <T1>s),

 

(list of supported <N2>s),

 

(list of supported <T2>s),

 

(list of supported <T3>s),

 

(list of supported <k>)

 

•_ +CME ERROR: <err>

SI C25-68003

The command is used to turn on the multiplexer. Only “no transparency is supported”. The parameter <k> is not used.

Owner’s Manual

Rev 1.0

Page 145 of 145