If the paperpark facilitydoesnot appearto be workingcorrectly,checkthe following:
Check
Is the paper release lever in the ~ position?
Has the fanfold paper been properly parked?
Possible remcxly
The paper release lever must be set to the ~ position after the fanfold paper has been parked.
Make sure that the POWERindicator comes on flashing after the fanfold paper has been parked.
If text is beingprintedall on one line, or with extrablank lines, checkthe following:
Check
Is the text all on the same tine?
Possible remedy
Carriage returns are not being expanded to <CR> + <LF> pairs. Check the DIP switch setting and correct.
Is text being printed with I Two line feeds are being printed. Either make your
extra blank lines?software print just a carriage return or (if this is not possible), settheAUTOLFto OFF with the DIP switch setting.
If thepagelengthandmarginsarenotwhatisexpected,checkthefollowing:
I Check | I Possible remedv | I |
Is the printing starting too | Use the Micro Feed facility to adjust the print position |
|
high or too low on the page? | relative to the page. |
|
Does the printer’s page | Use the DIP switch to setup the correct page length, or |
|
lengthnotmatchthe physical | use softwiwecommands to do it. |
|
page length? |
|
|
94
