
1.Press the( ON LINE ) button to set the printer
2.Press the m button and hold it down.
3. While holding the (FONT) button, press the ( | SEJ,ff&“T | |
) button. | ||
Each time you press the | button, | one of the indicators of |
FONT or PITCH will blink to show the current color as shown below.
4.Release both buttons after you set the desired printing color.
If you want to save the selected color for later use, store it using the Macro Definition.
NOTE: This function is valid only when the color ribbon is installed into the printer.
Store Macro Definition
You can store the current settings to the printer for later use with the following procedure:
1.Press the( ON LINE ) button to set the printer
2.Press the (FONT) button and hold it down.
3.While holding the (FONT)button down, press the (PITCH) button and hold them down until you hear two beep tones.
4.Release both buttons at the same time after the two beep tones to store the current setting.
If you release these buttons after three beep tones, the macro is cleared.
NOTE: You can store the following settings with this procedure.
•Current Font and Pitch
•Current
•Current
•Current
•Current print color
Data to be stored are controlled in Standard mode and IBM mode separately. For example, the data stored in the Standard mode are not effective in the IBM mode, and vice versa.
33