Star Micronics NX-1020 Forward micro-feed , Reverse micro-feed , Changing the auto loading value

3. Press and hold the ( ON LINE > button.
4. While holding the ( ON LINE )button down, press the @RR) button,
then release both buttons at the same time. The printer will beep to
indicate that the top-of-form position has been set.
Forward micro-feed
For fine alignment, you can feed the paper forward in very small increments
as follows:
1. Press the ( ON LINE ) button to set the printer off-line.
2. Press the ( ON LINE ) button again. and hold it down.
3. While holding the ( ON LINE ) buttondowqpressthe (PAPER FEED)
button. The paper will start advancing in a series of small steps. When
you want to stop, release both buttons.
Reverse micro-feed
You can also feed the paper in small increments in reverse, to return to a
higher position on the same page.
NOTE: With fanfold forms, do not try to return to a previous page. The per-
foration may catch inside the printer and cause a jam.
1. Press the ( ON LINE ) button to set the printer off-line.
2. Press the ( ON LINE ) button again and hold it down.
3. While holding the ( ON LINE ) button down, press the ( sEK5w’
button. The paper will start moving backwards in a series of small steps.
When you want to stop, release both buttons.
Changing the auto loading value
Normally, the printer automatically loads the paper one line from the top
edge.
If you want to change this value, follow this procedure:
1. Load the paper using the ( SEx~~CT ) button.
2. Change the print position using the micro feed function.
The line on the card holder helps you to align the baseline of characters
to be printed.
3. After you get the desired position, press the ( ON LINE ) button to save
the value.
31