Federal Communications Commission

Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and at, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

*Increase the separation between the equipment and receiver.

*Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radioDV technician for help.

Unauthorized modifications of this product by the user will void his authority to operate the equipment

 

unless expressly approved by the party responsible for compliance.

-

 

For compliance with the Federal Noise Interference Standard, this equipment requires a shielded cable.

 

The above statement applies only to printers marketed in the V.SA.

Statement of

The Canadian Department of Communications

Radio Interference Regulations

This digitalapparatus does not exceed theClass B limits for radionoiseemissions from digitalapparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le ptisent appareil numkique n’hen pas de bruits radioklectriques dCpassant les limites applicables aux appareils numCriques de la classe B prescrites dans le Reglement sur le brouillage radio&cnique

Cdict6 par le miniske des Communications du Canada.

The above statement applies only IOprinters marketed in Canada.

 

Trademark Acknowledgements

 

NX-1020, NX-1000, LC-10, ND-lo/H: Star Micronics Co., Ltd.

 

IBM PC, PC-AT, PC-XT,

Proprinter III, Proprinter II, PC-DOS: International Business Machines

-

Corp.

 

 

Microsoft BASIC, MS-DOS: Microsoft Corporation

 

FX-850,EX-800, LX-854

LX-810: Seiko Epson Corp.

 

NOTICE

All rights reserved. Reproduction of any part of this manual in any form whatsoever without

STAR’s express permission is forbidden.

. The contents of this manual are subject to change without notice.

. All efforts have been made to ensure the accuracy of the contents of this manual at the time of press. However, should any errors LXdetected, STAR would greatiy appreciate being informed of them.

. The above notwithstanding, STAR can assume no responsibility for any errors in this manual.

0 Copyright 1990 Star Micronics Co., Ltd.

Page 2
Image 2
Star Micronics NX-1020 user manual Ibm Pc, Pc-At, Pc-Xt