Check

Are you trying to feed paper using the front panel buttons while the ON LINE indicator is illuminated?

Is the paper too thick?

Possible remedy

You can only feed paper in this way when the printer is off-line. Set the printer off-line and then feed paper.

There are limits to the thickness of paper that can be fed in this way. Try using thinner paper.

If the ASF is not operating or is not feeding paper correctly, check the following:

Check

Has the ASF option been

selected with the EDS switch?

Is the release lever set to the C position?

Is the ASF correctly mounted?

Is paper caught up near the print head?

) ~~rr~r~~

Was the paper fanned before

being fed into the ASF?

w

Are you trying to feed paper using the front panel buttons while the ON LINE indicator

Possible remedy

Select this option.

The release lever should be set to the single-sheet position.

Make sure that the ASF is properly seated on the printer.

Stop printing, remove the jammed sheet (you may have to remove the ASF for this). and continue.

lf the left and right guides are too close together, the paper will not feed smoothly. Move them a little further

1aparttoallowthepapertofeedfreely.

The ASF’s paper feed hopper and stacker can hold 50 sheets each. Make sure that there is no more paper than this in either the hopper or stacker.

If this is not done, paper jams may occur. Remove the stack of paper from the ASF and fan it before reinsert-

Only new, uncreased paper should be used with the

You can only feed paper in this way when the printer is off-line. Set the printer off-line and then feed paper.

There are limits to the thickness of paper that can be fed in this way. Try using different paper.

111

Page 119
Image 119
Star Micronics NX-1020 user manual 111