Toshiba 351C, 451C, 281C manual 06/08

Error code	Classification		Contents	Troubleshooting
EA10	Finisher jam	Paper transport delay jam: The paper which has		P. 5-30
	(Finisher section)	passed the bridge
		unit does not reach the inlet sensor. [MJ-1022/
		1023/1024/1101]
EA20		Paper transport stop jam:		P. 5-32
		(1)	The paper does not pass through the inlet sen-
			sor.		2
		(2)	[MJ-1022/1023/1024]
			The paper has passed through the inlet sensor
			but does not reach or pass the feed path sensor
			or processing tray sensor.
		(3)	[MJ-1023/1024]
			The paper which has passed through the inlet
			sensor does not reach the transport sensor.
			[MJ-1101]
EA21		Paper size error jam: Paper does not reach the sen-		P. 5-33
		sor because the paper is shorter than spec. [MJ-
		1101]
EA30		Power-ON jam:		P. 5-34
		(1)	Paper exists at the inlet sensor when power is
			turned ON.
		(2)	[MJ-1022/1023/1024]
			Paper exists at the feed path sensor or pro-
			cessing tray sensor when power is turned ON.
			[MJ-1023/1024]
EA31		Transport path paper remaining jam: The paper		P. 5-35
		which has passed through the inlet sensor does not
		reach the transport sensor. [MJ-1101]
EA32		Exit paper remaining jam: The paper is remaining		P. 5-35
		on the finishing tray when the power is turned ON.
		[MJ-1101]
EA40	Finisher jam	Door open jam:		P. 5-36
	(Finisher section)	1)	The finisher has been released from the equip-
		2)	ment during printing. [MJ-1022]
			The upper/front cover of the finisher section or
			the upper/ front door of the puncher section has
		3)	opened during printing. [MJ-1023/1024]
			The front cover or stationary tray cover is
			opened during paper transport. [MJ-1101]
EA50		Stapling jam: Stapling is not performed properly.		P. 5-38
		[MJ-1022/1023/1024/1101]
EA60		Early arrival jam: The inlet sensor detects the paper		P. 5-40
		earlier than a specified timing. [MJ-1022/1023/
		1024/1101]
EA70		Stack delivery jam: It cannot deliver the stack of		P. 5-41
		paper on the intermediary process tray to the stack
		tray. [MJ-1022]
		Stack exit belt home position error: The stack exit
		belt is not at the home position. [MJ-1101]

© June 2005 TOSHIBA TEC e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE

2 - 5

06/08