Error Code and SELF-DIAGNOSTIC Mode | Toshiba 281C, 451C instruction

2.ERROR CODE AND SELF-DIAGNOSTIC MODE

The following error codes is displayed at the upper right of the screen when the CLEAR PAPER or CALL SERVICE symbol is blinking.

Error code	Classification	Contents	Troubleshooting
E010	Paper exit jam	Jam not reaching the exit sensor : The paper which	P. 5-1
		has passed through the fuser unit does not reach
		the exit sensor.
E020	Paper exit jam	Stop jam at the exit sensor: The trailing edge of the	P. 5-2
		paper does not pass the exit sensor after its leading
		edge has reached this sensor.
E030	Other paper jam	Power-ON jam: The paper is remaining on the	P. 5-18
		paper transport path when power is turned ON.
E061		Incorrect paper size setting for upper drawer: The	P. 5-18
		size of paper in the 1st drawer differs from size set-
		ting of the equipment.
E062		Incorrect paper size setting for lower drawer: The	P. 5-18
		size of paper in the 2nd drawer differs from size set-
		ting of the equipment.
E063		Incorrect paper size setting for PFP upper drawer:	P. 5-18
		The size of paper in the 3rd drawer differs from size
		setting of the equipment.
E064		Incorrect paper size setting for PFP lower drawer:	P. 5-18
		The size of paper in the 4th drawer differs from size
		setting of the equipment.
E065		Incorrect paper size setting for bypass tray: The	P. 5-18
		size of paper in the bypass tray differs from size
		setting of the equipment.
E090		Image data delay jam: Image data to be printed	P. 5-19
		cannot be prepared.

e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE

2 - 1