Safety notices

Maintenance safety

Do not attempt any maintenance procedure that is not specifically described in the documentation supplied with your product.

Do not use aerosol cleaners. The use of supplies that are not approved may cause poor performance of the press and could create a dangerous condition.

Use the supplies and cleaning materials only as directed in this manual. Keep all materials out of the reach of children.

Do not remove the covers or guards that are fastened with screws. There are no parts behind these covers that you can maintain or service.

Do not perform any maintenance procedures unless you have been trained to do them by a Xerox representative, or unless a procedure is specifically described in one of the manuals included with your press.

Operational safety

Your Xerox equipment and supplies were designed and tested to meet strict safety requirements. These include safety agency examination, approval, and compliance with established environmental standards.

Your attention to the following safety guidelines will help ensure the continued safe operation of your product:

Use the materials and supplies specifically designed for your product. The use of unsuitable materials may result in poor performance of the machine and possibly a hazardous situation.

Follow all warnings and instructions that are marked on or supplied with the machine.

Place the machine in a room that provides adequate space for ventilation and servicing.

Place the machine on a level, solid surface (not on a thick pile carpet) that has adequate strength to support the weight of the machine.

Do not attempt to move the machine. A leveling device that was lowered when your machine was installed may damage the carpet or floor.

Do not set up the machine near a heat source.

Do not set up the machine in direct sunlight.

FreeFlow Scanner 665E Operator Manual

xiii

Page 15
Image 15
Xerox 701P44148 manual Maintenance safety, Operational safety