154Troubleshooting Printer Diagnostics
FEED + PAUSE Self Test
Performing this self test temporarily resets the printer configuration to the factory default values. These values are active only until power is turned off unless you save them permanently in memory. If the factory default values are permanently saved, a sensor calibration procedure must be performed. (See Calibrate the Ribbon and Media Sensors Manually on page 106.)
To perform a FEED and PAUSE self test, complete these steps:
1.Turn off (O) the printer.
2.Press and hold FEED + PAUSE while turning on (I) the printer.
3.Hold FEED + PAUSE until the first control panel light turns off.
The printer configuration is reset to the factory default values. No labels print at the end of this test.
CANCEL + PAUSE Self Test
Performing this self test temporarily resets the network configuration to the factory default values. These values are active only until power is turned off unless you save them permanently in memory.
To perform a CANCEL and PAUSE self test, complete these steps:
1.Turn off (O) the printer.
2.Press and hold CANCEL + PAUSE while turning on (I) the printer.
3.Hold CANCEL + PAUSE until the first control panel light turns off.
The printer’s network configuration is reset to the factory default values. No labels print at the end of this test.
7/3/13 |