Printer Setup and Operation 43

Connect the Printer to a Power Source

Connect the Printer to a Power Source

The AC power cord must have a three-prong female connector on one end that plugs into the mating AC power connector at the rear of the printer. If a power cable was not included with your printer, refer to Power Cord Specifications on page 44.

Caution • For personnel and equipment safety, always use an approved three-conductor power cord specific to the region or country intended for installation. This cord must use an IEC 320 female connector and the appropriate region-specific three-conductor grounded plug configuration.

To connect the printer to a power source, complete these steps:

1.Plug the female end of the A/C power cord into the A/C power connector on the back of the printer.

2.Plug the male end of the A/C power cord into an appropriate power outlet.

115 V AC

230 V AC

7/3/13

P1056468-002