44Printer Setup and Operation Connect the Printer to a Power Source

3.Turn on (I) the printer.

The printer boots up and performs a self-test.

Power Cord Specifications

Caution • For personnel and equipment safety, always use an approved three-conductor power cord specific to the region or country intended for installation. This cord must use an IEC 320 female connector and the appropriate region-specific, three-conductor grounded plug configuration.

Depending on how your printer was ordered, a power cord may or may not be included. If one is not included or if the one included is not suitable for your requirements, see Figure 5 and refer to the following guidelines:

•The overall cord length must be less than 9.8 ft. (3 m).

•The cord must be rated for a minimum of 10 A, 250 V.

•The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic interference.

P1056468-002

7/3/13