Zebra Technologies ZT400 manual Sensors Menu, 113, Select the Media Sensor, Print a Sensor Profile

Printer Configuration and Adjustment

User Menus—SENSORS Menu

SENSORS Menu

Items in this menu are shown in the order in which they appear when you press the RIGHT ARROW. For more information about these settings, see Table 6, Sensor Settings on page 86.

113

SENSOR TYPE

▼ TRANSMISSIVE ▲

Select the Media Sensor

Select the media sensor that is appropriate for the media that you are using. The reflective sensor typically is used only for black mark media. The transmissive sensor typically is used for other media types.

See Sensor Type on page 86 for more information.

MEDIA/RIBBON CAL

START

PRINT INFORMATION

▼ SENSOR PROFILE ▲

PRINT

LABEL SENSOR

▼ 204▲

Calibrate the Media and Ribbon Sensors

Use this menu item to adjust the sensitivity of the media and ribbon sensors.

For instructions on how to perform a calibration procedure, see Calibrate the Ribbon and Media Sensors on page 119.

Print a Sensor Profile*

Use this menu item to print a sensor profile.

See Print Information on page 71 or Sensor Profile on page 170 for more information.

* Other options are available by scrolling.

Set the Sensitivity of the Label Sensor

Important • This value is set during sensor calibration. Do not change this setting unless you are told to do so by Zebra Technical Support or by an authorized service technician.

See Label Sensor on page 86 for more information.

4/8/14 ZT400 Series™ User Guide P1066582-002