Zebra Technologies ZT400 manual Feed + Pause Self Test, Cancel + Pause Self Test, 168

168

Troubleshooting

Printer Diagnostics

FEED + PAUSE Self Test

Performing this self test resets the printer configuration to the factory default values. Perform a sensor calibration after this self test. (See Calibrate the Ribbon and Media Sensors

on page 119.)

To perform a FEED and PAUSE self test, complete these steps:

1.Turn off (O) the printer.

2.Press and hold FEED + PAUSE while turning on (I) the printer.

3.Hold FEED + PAUSE until the first control panel light turns off.

The printer configuration is reset to the factory default values. No labels print at the end of this test.

CANCEL + PAUSE Self Test

Performing this self test resets the network configuration to the factory default values.

To perform a CANCEL and PAUSE self test, complete these steps:

1.Turn off (O) the printer.

2.Press and hold CANCEL + PAUSE while turning on (I) the printer.

3.Hold CANCEL + PAUSE until the first control panel light turns off.

The printer’s network configuration is reset to the factory default values. No labels print at the end of this test.

P1066582-002 ZT400 Series™ User Guide 4/8/14