Zebra Technologies ZT400 manual Ezpl.reprintmode, Reprint, Mode, Maximum, Label Length

70

Printer Configuration and Adjustment

Adjust Printer Settings

Table 1 • Print Settings (Continued)

Reprint	When reprint mode is enabled, you can reprint the last label printed by pressing and holding
Mode	PAUSE + CANCEL on the printer’s control panel.
	Accepted values:	•	ON
		•	OFF
	Related ZPL command(s):	^JZ
	SGD command used:	ezpl.reprint_mode
	User menu item:	REPRINT MODE on page 95
	Printer web page:	N/A
Maximum	Set the maximum label length to a value that is at least 1.0 in. (25.4 mm) greater than the
Label Length	actual label length plus the interlabel gap. If you set the value to one that is smaller than the
	label length, the printer assumes that continuous media is loaded, and the printer cannot
	calibrate.

For example, if the label length is 6.0 inches (152 mm) including the interlabel gap, set the parameter for at least 7.0 inches (178 mm).

1 3

2

1Label length (including interlabel gap)

2Interlabel gap

3Set the maximum label length to approximately this value

Accepted values:	0 to the maximum label length supported by the printer
Related ZPL command(s):	^ML
SGD command used:	ezpl.label_length_max
User menu item:	LABEL LENGTH MAX on page 96
Printer web page:	View and Modify Printer Settings > Media Setup >
	Maximum Length

P1066582-002 ZT400 Series™ User Guide 4/8/14