Zebra Technologies ZT400 manual Ezpl.printmethod, Print Method, Tear-Off, Position, Tear OFF on

68

Printer Configuration and Adjustment

Adjust Printer Settings

Table 1 • Print Settings (Continued)

Print Method	Specify if the printer is to use Direct Thermal mode (no ribbon) or Thermal Transfer mode
	(using thermal transfer media and ribbon).
	Accepted values:	•	THERMAL TRANS
		•	DIRECT THERMAL
	Related ZPL command(s):	^MT
	SGD command used:	ezpl.print_method
	User menu item:	PRINT METHOD on page 94
	Printer web page:	View and Modify Printer Settings > Media Setup > Print
			Method
Tear-Off	If necessary, adjust the position of the media over the tear-off bar after printing.
Position	• Higher numbers move the media out (the tear line moves closer to the leading edge of
	the next label).

•Lower numbers move the media in (the tear line moves closer to the edge of the label just printed).

1

2

1Media direction

2Factory-set tear line location at position 000

Accepted values:	–120 to 120
Related ZPL command(s):	~TA
SGD command used:	ezpl.tear_off
User menu item:	TEAR OFF on page 95
Printer web page:	View and Modify Printer Settings > General Setup >
	Tear Off

P1066582-002 ZT400 Series™ User Guide 4/8/14