Zebra Technologies ZT400 manual Load the Ribbon on

50

Printer Setup and Operation

Load the Media—Peel-Off Mode (with our without Liner Take-Up)

9.Does the media that you are using require ribbon for printing? If you are not sure, see When to Use Ribbon on page 18.

	If using…	Then…
	Direct Thermal media (no ribbon needed)	Continue with step 10.
	Thermal Transfer media (ribbon needed)	a.	If you have not already done so,
			load ribbon in the printer. See
			Load the Ribbon on page 60.
		b. Continue with step 10.
10. Close the media door.

11.Set the printer to Peel-Off mode (for more information, see Print Mode on page 69).

12.Press PAUSE to exit pause mode and enable printing.

The printer may perform a label calibration or feed a label, depending on your settings.

13.If desired, perform the CANCEL Self Test on page 163 to verify that your printer is able to print.

Media loading in Peel-Off mode is complete.

P1066582-002 ZT400 Series™ User Guide 4/8/14