Zebra Technologies ZT400 Ezpl.manualcalibration, Device.diagnosticprint

			Printer Configuration and Adjustment
			Adjust Printer Settings
	Table 2 • Calibration and Diagnostic Tools (Continued)
Media and	Calibrate the printer to adjust the sensitivity of the media and ribbon sensors.
Ribbon Sensor	For complete instructions on how to perform a calibration procedure, see Calibrate the
Calibration	Ribbon and Media Sensors on page 119.
	Accepted values:	N/A
	Related ZPL command(s):	~JC
	SGD command used:	ezpl.manual_calibration
	User menu item:	MEDIA/RIBBON CAL on page 98
	Control panel key(s):	Hold PAUSE + FEED + CANCEL for 2 seconds to
		initiate calibration.
	Printer web page:	The calibration procedure cannot be initiated through
		the web pages. See the following web page for
		settings that are set during sensor calibration:
			View and Modify Printer Settings > Calibration
			Important • Do not change these settings
			unless you are told to do so by Zebra
			Technical Support or by an authorized service
			technician.
Communication	Use this diagnostics tool to cause the printer to output the hexadecimal values for all
Diagnostics Mode	data received by the printer.
	For more information, see Communication Diagnostics Test on page 169.
	Accepted values:	•	DISABLED
		•	ENABLED
	Related ZPL command(s):	~JD to enable, ~JE to disable
	SGD command used:	device.diagnostic_print
	User menu item:	DIAGNOSTIC MODE on page 99
	Control panel key(s):	Hold PAUSE + FEED for 2 seconds when the printer
		is in the Ready state.
	Printer web page:	N/A

75

4/8/14 ZT400 Series™ User Guide P1066582-002