Zebra Technologies ZT400 manual B0 to B30, Rfid.position.program, Rfid.reader1.antennaport

		Printer Configuration and Adjustment
		Adjust Printer Settings
	Table 4 • RFID Settings (Continued)
Programming	If the desired programming position (read/write position) is not achieved through RFID
Position	tag calibration, a value may be specified. See the RFID Programming Guide 3 for more
	information.
	Accepted values:	F0 to Fxxx (where xxx is the label length in
		millimeters or 999, whichever is less)
		The printer feeds the label forward for the
		specified distance and then begins
		programming.
		B0 to B30
		The printer backfeeds the label for the
		specified distance and then begins
		programming. To account for the backfeed,
		allow empty media liner to extend out of the
		front of the printer when using a backward
		programming position.
	Related ZPL command(s):	^RS
	SGD command used:	rfid.position.program
	User menu item:	RFID PROGRAM POS. on page 109
	Printer web page:	View and Modify Printer Settings > RFID Setup >
		PROGRAM POSITION
RFID Antenna	If the desired antenna is not achieved through RFID tag calibration, a value may be
Element	specified.
	Note • This parameter does not apply to ZD500R printers, which always use an
	antenna element value of A1.
	Accepted values:	A1, A2, A3, A4
		B1, B2, B3, B4
		C1, C2, C3, C4
		D1, D2, D3, D4
		E1, E2, E3, E4
	Related ZPL command(s):	^RW
	SGD command used:	rfid.reader_1.antenna_port
	User menu item:	RFID ANTENNA on page 109
	Printer web page:	View and Modify Printer Settings > RFID Setup >
		RFID ANTENNA

81

4/8/14 ZT400 Series™ User Guide P1066582-002