Command Reference Guide Router (PIM Sparse) Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1129

ROUTER (PIM SPARSE) CONFIGURATION COMMAND SET

To activate the Router (PIM Sparse) Configuration mode, enter the router pim-sparse command at the
Global Configuration mode prompt . For exa mp l e:
>enable
#
configure terminal
(config)#
router pim-sparse
(config-pim-sparse)#
The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
join-prune-msg-interval <seconds> on page 1130
rp-address <ip address> access-group <access-list-name> on page 1131
spt-threshold <packets> infinity on page 1133