Command Reference Guide DSX-1 Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 500

DSX-1 INTERFACE CONFIGURATION COMMAND SET

To activate the DSX-1 Interface Configuration mode, enter the interface t1 command (a nd specify the
DSX-1 port) at the Global Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
interface t1 1/2
(config-t1 1/2)#
The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
coding [ami | b8zs] on page 501
framing [d4 | esf] on page 502
line-length <value> on page 503
loopback network [line | payload] on page 504
loopback remote line [inband] on page 505
remote-loopback on page 506
signaling-mode [message-oriented | none | robbed-bit] on page 507
snmp trap link-status on page 508
test-pattern [ones | zeros] on page 509