ADTRAN 5000 Series ENABLE MODE COMMAND SET

Command Reference Guide Enable Mode Command Set

ENABLE MODE COMMAND SET

To activate the Enable mode, enter the enable command at the Basic mode prompt. (If an enable password

has been configured, a password prompt will display.) For example:

>enable

Password: XXXXXXX

The following command is common to multiple command sets and is covered in a centralized section of

this guide. For more information, refer to the section listed below:

exit on page 34

All other commands for this command set are described in this section in alphabetical order.

clear commands begin on page 38

clock auto-correct-dst on page 76

clock no-auto-correct-dst on page 77

clock set <time> <day> <month> <year> on page 78

clock timezone <text> on page 79

configure [memory | network | overwrite-network | terminal] on page 82

copy <source> <destination> on page 83

copy console <filename> on page 84

copy flash <destination> on page 85

copy <filename> interface <interface> <slot/port> on page 86

copy tftp <destination> on page 87

copy xmodem <destination> on page 88

debug commands begin on page 89

dir on page 141

dir [<input> | flash | flash <input>] on page 142

disable on page 143

enable on page 144

erase [<filename> | startup-config] on page 145

events on page 146

exception report generate on page 147

logout on page 148

ping <address> on page 149

reload [cancel | in <delay>] on page 151

show commands begin on page 152