Command Reference Guide Loopback Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 846

LOOPBACK INTERFACE CONFIGURATION COMMAND SET

To activate the Loopback Interface Configuration mode, enter the interface loopback command at the
Global Configuration mode prompt . For exa mp l e:
>enable
#
configure terminal
(config)#
interface loopback 1
(config-loop 1)#
The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 847
bandwidth <value> on page 850
crypto map <mapname> on page 851
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on
page 853
ip commands begin on page 855
ip commands begin on page 856
mtu <size> on page 880
snmp trap on page 881
snmp trap link-status on page 882