ADTRAN 5000 Series DHCP POOL COMMAND SET

Command Reference Guide DHCP Pool Command Set

DHCP POOL COMMAND SET

To activate the DHCP Pool mode, enter the ip dhcp-server pool command at the Global Configuration

mode prompt. For example:

>enable

configure terminal

(config)#

ip dhcp-server pool MyPool

(config-dhcp)#

The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>

on page 28

do on page 32

end on page 33

exit on page 34

shutdown on page 35

All other commands for this command set are described in this section in alphabetical order.

client-identifier <identifier> on page 1146

client-name <name> on page 1148

default-router <address> <secondar y> on page 1149

dns-server <address> <secondary> on page 1150

domain-name <d omain> on page 1151

hardware-address <hardware-address> <type> on page 1152

host <address> [<subnet mask> or <prefix length>] on page 1154

lease <days> <hou rs> <minutes> on page 1155

netbios-name-server <address> <secondary > on page 1156

netbios-node-type <type> on page 1157

network <address> [<subnet mask> or <prefix length>] on page 1158

ntp-server <ip address> on page 1159

option <option value> [ascii | hex | ip] <value> on page 1160

tftp-server <server> on page 1161

timezone-offset <offset> on page 1162