ADTRAN 5000 Series - page 218

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 218
The following example shows sample output from the show ip pim-sparse interfaces command:
>enable
#show ip pim-sparse interface
eth 0/1 is UP
PIM Sparse
DR: itself
Local Address: 192.168.1.254
Hello interval (sec): 30, Neighbor timeout (sec): 105
Propagation delay (ms): 500, Override interval (ms): 2500
tunnel 1 is UP
PIM Sparse
DR: 172.16.1.10
Local Address: 172.16.1.9
Hello interval (sec): 30, Neighbor timeout (sec): 105
Propagation delay (ms): 500, Override interval (ms): 2500
tunnel 2 is UP
PIM Sparse
DR: 172.16.2.10
Local Address: 172.16.2.9
Hello interval (sec): 30, Neighbor timeout (sec): 105
Propagation delay (ms): 500, Override interval (ms): 2500
The following example shows sample output from the show ip pim-sparse neighbor command:
>enable
#show ip pim-sparse neighbor
Port Neighbor Holdtime(sec) Age(sec) Uptime(sec)
------------------------------------------------------------------------------------------------------
tunnel 1 172.16.1.10 105 19 241908
tunnel 2 172.16.2.10 105 23 241913