Command Reference Guide Line (Telnet) Interface Config Command Set
61200990L1-35E Copyright © 2005 ADTRAN 491

LINE (TELNET) INTERFACE CONFIG COMMAND SET

To activate the Line (Telnet) Interface Configuration mode, enter the line telnet command specifying a
Telnet session(s) at the Global Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
line telnet 0 4
(config-telnet0-4)#
You can select a single line by entering the line telnet co mmand follo wed by the line number (0-4). For
example:
>enable
#
configure terminal
(config)#
line telnet 2
(config-telnet2)#
The following comm a nd s are com mo n to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-class <listname> in on page 492
accounting commands [<level> l <name> l default] on page 493
authorization commands [<level> l <name> l default] on page 494
line-timeout <minutes> on page 495
login on page 496
login authentication <aaa login list> on page 497
login local-userlist on page 498
password [md5] <password> on page 499