ADTRAN 5000 Series set default interface <interface type> <interface id>

Command Reference Guide Route Map Command Set

set default interface <interface type> <interface id>

Use the set default interface command to specify an output interface for the packet if there is no explicit

route destination. Multiple interfaces can be specified but they must be point-to-point. The router forwards

the packet along the first usable interface. Use the no form of this command to cancel output from the

specified interface.

Syntax Description

<interface> Sets defau lt interface type . Type set default interface ? for a list

of valid interfaces.

<interface id> Specifies the ID of the specified interface type.

Default Values

No default value necessary for this command.

Applicable Platforms

This command applies to the NetVanta 2000 and 5000 Series, and Total Access 900 Series units.

Command History

Release 11.1 Command was introduced.

Usage Examples

The following example sets the default interface as PPP 1:

(config)#route-map MyMap permit 100

(config-route-map)#set default interface ppp 1